A world in a sand，a heaven in a flower，holding infinity in both hands，an instant is eternity.

● NOTE: The air is about 5mm high, the sand will reach a good flow rate.

Quicksand falling too fast: add some air

1, the same method as above, focus the air to any one of the corners with air holes, to determine the sand move away.

2、Insert the air hole with an air regulator.

Quicksand falling too slow: pump out some air

1、Each round quicksand art painting has a hole, concentrate the air to any corner with air hole , Wait for the sand to move away.

2、Insert an air regulator into the air hole.

If a lot of small bubbles in the quicksand painting become a particularly large bubble, this time can be filled with a little water to replenish the evaporation of water.

1、Be sure to use pure water or boiled water to cool;

2、Select an air hole, wait for the sand to move away, pump out some air and empty the air regulator tube;

3、Then use the air regulator to pump in and fill with too much water to prevent the pressure from being too high and the glass from breaking.

It can be given to parents, lovers, friends, children as a gift on birthdays or holidays.

Usage Guide:

1. Put the sand painting on the shelf for at least 30 minutes;
2. Pick up the sand painting and shake it gently to turn the air inside into small bubbles, then turn it over to let the sand slowly flow down from the small bubbles.
3. After the sand has completely fallen, let it sit on the shelf for at least 30 minutes, and then turn it over.

Kindly Reminders:

• Please don't use excessive force when shaking the sand painting. If you use too much force and the bubbles are small and dense, the buoyancy of the bubbles will be too great, the sand may fall too slowly, which makes it looks like that sand cannot flow down.
• If you accidentally let the air become small and dense bubbles, you only need to let it stand for a few hours or days, and the bubbles will gradually become larger and disappear.
• After each flow, let it stay on the shelf for at least 30 minutes to allow the sand to compact. If you turn it over immediately after each flow, because the sand is too loose, it will fall in large pieces soon, so you can't see the scenery of the sand slowly falling.
• The ratio of air and water has been balanced before leaving the factory. Under normal circumstances, there is no need to adjust air and water.
• If you want to adjust the water and air, be careful not to add too much water at once. If the water pressure is too high, the glass will shatter.

Special Notice:

There are strict initial standards for the amount of air in sand paintings. Water will evaporate, because there is no absolutely airtight environment for this handmade product. Over time, the air inside may increase. In the hot summer, water will evaporate faster. At this time, the amount of air may need to be adjusted. This is easy to handle. You need a syringe with a thin needle and some clean water. A disposable syringe is sufficient. There is a small hole on the side of the rubber ring. Find the small hole and let the air come up and the sand sink. Insert the syringe into the rubber to adjust the water and air. The number of bubbles will directly affect the speed of the quicksand. The more air, the slower the flow rate. And the less air, the faster the flow rate. The most important thing is that the amount of water injected is the same as the amount of air extracted. In addition, please do not do this too many times, as this may damage the air tightness of the rubber.

Warning: This product is glassware. Children under 8 years old should not be used alone. It can only be used under adult supervision.

Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. Please allow 1-2 inch error due to manual measurement. Thanks for your understanding.